The main points of the process of making a computerized flat knitting machine

The main points of the process of making computerized flat knitting machines have gradually become the mainstream of sweater knitting processes due to the popularity of computerized flat knitting machines . However, the technology of the machine lags behind, the quality of the vehicle-blocking workers is uneven, and even the masters of the plate-making masters are insufficient, resulting in many new drawbacks. These are all obvious to you and will not be enumerated. We can adapt the characteristics of the computerized flat knitting machine to some details of the process, and also improve the quality and output of the computerized flat knitting machine.
1. The computerized flat knitting machine is combed from the right to the left, that is, from the tail of the machine. Therefore, in the ribbed number, the fine needle is woven by 1.5 turns, and the thick needle is woven by the number of ribs. 5 turns to cooperate;
Second, the parity of the needle should be matched with the pattern to maintain the symmetry of the pattern;
Third, because the rib structure and the large body need to be in the needle position and needle, and the number of needles can not exceed 1/3 of the needle;
4. For the color of the clip, the end color of the web should be indicated; for the pit shirt, the number of stitches in the pit should be indicated in the key parts such as the over-comb and the end of the retractable needle; for the twisted flower, each strand should be marked. Number of
5. After the flat collection, the computerized flat knitting machine needs at least 0.5 rpm, and then the needle is received; if it is concealed, regardless of the needle type, it is made into one 1 piece;
6. When the computerized flat knitting machine is used to stop the needle (also called the shovel needle), the number of revolutions should not exceed 4CM. If it is necessary to exceed, the paragraph yarn is released;
Seven, some of the footage needs to be straight, but even if it is 0.5 rpm and then 1 rpm, it will not be straight. The computerized flat knitting machine can be retracted and retracted once at 0.5 rpm, and then retracted and retracted once, so that it is retracted and retracted. Can reach a straight line;
Eight, when collecting and making patterns or symbols in the middle of the film, if you press the flat knitting machine format such as "receive the first few flowers" or "how to add the first few stitches...", the plate-making master has a headache. He has to count how many turns and how many turns, it is necessary to locate, the correct should be to directly give the number of revolutions such as "how many turns in the foot to receive", "or how many turns on the foot or how many marks left on the tail", etc. Wait;
Nine, the computerized flat knitting machine can not finish the stitches of the film at the end, and must have 3 or 5 stitches left;
Ten, some thresholds are out of the original, STOLL machine can give segment density control at the threshold, but other machines do not seem to work, this can be achieved by stealing the number of turns in the threshold; (hehe, this is a bit of a technical term the taste of)
XI. Because the computerized flat knitting machine is used for the structure of the covered wire, the needle on the side of the strip is easy to take up the flower and the opposite side of the silk. Therefore, if it is possible to do the teeth for the teeth, it is recommended to cancel the cover wire.
12. All the tissues on the bottom of the Lamy are to be completely finished. The computerized flat knitting machine is electronically controlled. It can be expressed, for example, how close the bottom surface is, so that it can be adjusted and controlled by the driver.
Thirteen, because of the characteristics of the computerized flat knitting machine , the size of the light shrinkage can not control the density very well, should be combined with the compaction, hanging length, and the combination of the shrinkage pieces to be more accurately controlled;